Saving energy at home can start with changes in how you use your home, before you consider a renovation. Adjusting the heating, ventilating thoughtfully and avoiding unnecessary electricity use are simple measures; their effects depend on the home, the climate and the equipment installed.

The temperature and ventilation guidance in this article is based on recommendations for households in Germany. These are not universal values: insulation, humidity, occupancy and heating type all matter. If you rent, consult your landlord before changing installations or fixed building components.

1. Start with heating and everyday habits

Adjust the temperature without letting rooms get too cold

As a guide for homes in Germany, Verbraucherzentrale recommends around 20 °C in the living room, 18 °C in the bedroom and 16 °C in rooms used infrequently. On common thermostats, setting 3 usually corresponds to approximately 20 °C. The temperature needed also depends on the condition of the building and humidity; during the heating season, the general guidance for living spaces is to keep them at least between 16 and 18 °C.

A programmable thermostat lets you set schedules and lower the temperature when you are away or at night. The same schedule should not automatically be applied to every system: heat pumps usually work better without setback periods. Avoid letting rooms get excessively cold, as cold and humidity can increase the risk of mould.

Keep radiators unobstructed so heat can circulate around the room. Furniture and curtains covering them can impede heat distribution.

Ventilate quickly and regularly

During the heating season, open windows fully for a few minutes rather than leaving them tilted open for a long time. If possible, open opposite windows to create cross-ventilation. Turn down the thermostat while ventilating and readjust it afterwards.

How often and for how long to ventilate depends on occupancy, humidity, climate and the building. In winter, air can be exchanged quickly; after showering, cooking or bathing, ventilate promptly to remove excess moisture. A hygrometer can help you monitor relative humidity, but it does not replace investigating persistent condensation or mould problems.

There is no single ventilation routine for every home. In rooms with cold walls, such as some basements, ventilating when the outdoor air is warm and humid can raise humidity on surfaces. Significant damp or extensive mould may have structural causes that require qualified advice.

Check radiators and heating controls

If a radiator gurgles or does not heat evenly, there may be air in the system. Bleeding it may help, but check the system pressure afterwards. In buildings with central heating, consult the building manager or maintenance staff before intervening, especially if water needs to be added to the system. If the problem persists, it may be due to other system settings.

Schedules, the heating curve and the flow temperature depend on the system and the building. If you need to change them or the heating does not respond as expected, seek qualified advice.

2. Reduce heat loss with simple checks

Check whether windows close properly

To check a closing point, place a sheet of paper between the frame and the window sash and close the window. If you cannot pull the paper out, that point is sealed; if it comes out easily, the window may not close properly. Repeat the test in several places. In some cases, replacing a seal or adjusting the sash may be enough instead of replacing the window.

If you rent, consult your landlord before working on windows, doors or other fixed components. Seals must be suitable for the frame and fitted correctly.

Consider improvements in the context of the building

Uninsulated heating pipes in unheated spaces can lose heat. Uninsulated radiator recesses and roller-shutter boxes can also be weak points. Whether and how to make improvements depends on the building; if the work affects fixed components, consult your landlord and seek qualified advice when necessary.

3. Reduce electricity use

Avoid unnecessary standby consumption

Some appliances continue to use electricity even when they appear to be switched off. A switched power strip can make it easier to turn off several devices together when they do not need to stay connected. Check the manual before disconnecting them: some devices require a connection or perform tasks after use.

When buying an appliance, compare the annual consumption shown on the energy label as well as its efficiency class. Replacing an old appliance can reduce consumption, but the financial savings depend on how it is used and the appliance’s cost. An electricity meter can help identify how much a device uses while running or in standby.

Use household appliances efficiently

  • Refrigerator: As a guide, 7 °C in the upper compartment is usually sufficient; the recommended temperature for the freezer is −18 °C. Keep the doors open for as little time as possible and defrost if ice builds up.
  • Dishwasher: Wait until it is fully loaded and use the Eco programme. Pre-rinsing dishes is usually unnecessary; remove large food scraps.
  • Washing machine: Load the drum appropriately and choose low temperatures when suitable. Eco programmes can save energy and water; air-drying clothes avoids using a tumble dryer.
  • Cooking: Cook with a lid and heat only as much water as you will use. A fan oven may use less energy than conventional top-and-bottom heat; for some dishes, you can also skip preheating.
  • Lighting: Replace incandescent or halogen bulbs with LEDs and switch off lights you do not need.
  • Computers and entertainment: Use energy-saving or sleep mode. Turn off consoles and other equipment completely if they do not need to remain connected.

The effect of these measures depends on habits and the specific appliances. A household electricity-use estimation guide can help identify what to check first.

A practical order to get started

Priority What to do Important limitation
1 Adjust heating and schedules; keep radiators unobstructed Avoid letting rooms get excessively cold; heat pumps usually work better without setback periods.
2 Ventilate quickly and promptly remove moisture from showers, baths and cooking Frequency depends on the home and climate.
3 Switch off unnecessary devices and use efficient programmes Check which devices need to remain connected.
4 Check seals and visible weak points Work on fixed components may require permission or technical assistance.
5 Consider improvements to pipes, windows or insulation The appropriate measure depends on the building and its systems.

A week of observation

For one week, note the temperatures in the rooms you use most, when you ventilate, whether condensation appears on the windows and which appliances remain on standby. Then try one change at a time, such as clearing a radiator, adjusting the heating schedule or switching off a power strip at night.

This exercise does not calculate guaranteed savings or replace an energy assessment. It can help identify changeable habits and signs that deserve attention, such as persistent damp or heating that does not reach the desired temperature.

When to seek advice

Consult the building manager or landlord before intervening in a central heating system or components of a rented home. Seek qualified advice if you need to change technical settings or address persistent damp. To review electricity use, an electricity-use estimation guide can complement these recommendations.

At a glance

Nexo request

  • 288
  • nexo:broken-link:288:priority:v1
  • Energiespartipps für Zuhause: Heizen, Lüften, Warmwasser und Strom
  • de
  • House Angle no tiene en alemán una guía general de consejos de ahorro de energía en casa (solo la guía de estimación de consumo eléctrico, que sirve como complemento). Propuesta (de): «Energiespartipps für Zuhause: Heizen, Lüften, Warmwasser und Strom», para propietarios e inquilinos: temperatura y programación de la calefacción, ventilación por choque, purgar radiadores, juntas de ventanas, ducha/agua caliente, standby y electrodomésticos eficientes, con orden de prioridad y ahorros orientativos; es la función del recurso de co2online («Energiespartipps») que enlazaba la página.
  • https://www.energiewende-erlangen.de/klimaschutztipps/nachhaltige-energieversorgung-und-nutzung/energieeffizienz-energieeinsparung/
  • https://www.klima-sucht-schutz.de/service/energiespartipps/
  • 6a85fab39468da9f3ebac7e9a255a4f9d71fd66e7199bdf77c9d198f20b17017

Priority authorization

  • explicit_owner_instruction
  • 288
  • highest_native
  • 1
  • 1
  • 1

Required locales

  • es
  • en
  • fr
  • it
  • de
  • pt

Research required

1

Sources and references

Heizung: 10 einfache Tipps zum Heizkosten sparen | Verbraucherzentrale.de ↗19/11/2026 Verbraucherzentrale, “Heizung: 10 einfache Tipps zum Heizkosten sparen”.

Heizen und Lüften: So geht's richtig | Verbraucherzentrale.de ↗19/11/2026 Verbraucherzentrale, “Heizen und Lüften: So geht's richtig”.

Strom sparen im Haushalt: Einfache Tipps | Verbraucherzentrale.de ↗19/11/2026 Verbraucherzentrale, “Strom sparen im Haushalt: Einfache Tipps”.